Protocol tab

On this tab (Fig. 1) you can find detailed information concerning a particular communication protocol.

Figure 1: Protocol tab

After selecting one of the protocols, you can find protocol parameters set during configuration. The program shows the following parameters:

• „Rx data +” – number of successful read operation

• „Rx data -” – number of unsuccessful read operation

• „Tx data +” – number of successful write operation

• „Tx data -” – number of unsuccessful write operation

In the right column, the program provides the following information:

• TX frames – number of successfully sent frames

• CRC errors – number of CRC errors

• Incomplete frames – number of incomplete frames

• Time-out count – number of timeouts

• Invalid rx frames – number of invalid (BAD) frames (the received frame has an unexpected type, an unknown frame attribute was received, the frame is from a protocol other than the used one)

• Rx synchro errors – number of synchronization errors

• NAK counter – number of received NAK (negative acknowledge)

• Max response [ms] – waiting time (in milliseconds) for the first character in response (minimum/average/maximum)

• Max char gap [us] – waiting interval (in microseconds) between characters in response (minimum/average/maximum)